Polishing Pads are nanoscale silica particles mixed with a binder and efficient, uniformly coated on the surface of the polyester film, made by drying and curing reaction.
Brief introduction
Since the primary particle Polishing Pads fine, particle size less than the wavelength of visible light, so the appearance of transparent or translucent film is formed after polishing is uniformly distributed. Specifically for fiber optic connector polishing the final design and development of ultra-precision connector end face without any scratches or defects after use, and highly reflective fiber attenuation indicators have reached international standards.
Instructions
Just add pure water as a polishing grinding media use. In the process of polishing grinding, polishing film nano-coating will gradually release polishing particles involved in polishing action, so that the fiber ends to achieve a high degree of smoothness. Lapping film can be reused many times, but depending on the type of polishing grinding, polishing grinding conditions Polishing Pads different quality requirements, the frequency of use is not the same.
(1) determine the fiber end face grinding after no abnormal deep scratches or defects;
(2) Thoroughly clean the grinder jigs and rubber mats and other parts, in particular to ensure that the rubber pad surfaces in good condition, no foreign body;
(3) to spray the surface of the rubber pad was right amount of pure water, and wipes evenly smear, when the surface of the early dry, immediately polishing membrane attached to the top;
(4) uniformly sprayed a small amount of pure water to the polishing surface of the film, even wipe with wipes, out of the air below the polished film;
(5) polishing the film surface by blowing compressed air, to remove dust or foreign matter;
(6) again polished film surface evenly sprayed right amount of pure water;
(7) at light fixture connector, the connector end faces in uniform contact with the polishing film, and then applying an appropriate pressure, set polishing time to start polishing mill began;
(8) grinding machine stops working, carefully remove the fixture, remove the polishing film, dry and ready for use again.